Since my welcome post included how to tie a tie, i figured i should post an article about this. Maybe you got a new job which requires you to wear a tie, or maybe you have an interview; whatever the case is, you will leave this blog with knowing how to tie a tie. I never knew how to tie a tie until recently because I got a job for which I have to wear a suit. So here it goes:
Step 1: Flip up your collar, button down the top button, and lay the necktie around your neck so that the wide end of the tie hangs 5-6 inches lower than the narrow end. Make sure that the inseam of the tie faces you body.
Step 2: Place the wide end of the necktie over the narrow end, and wrap around. Hold the narrow end down with your other hand.
Step 3: Then, wrap the wide end over the narrow end. Don’t pull it tight, but create a loop at front of the unfinished tie knot.
Step 4: Then, loop the wide end of the tie through the gap between unfinished tie knot and your collar. Then take this wide end of the tie and pull it through the loop you created on step #3.
Step 5: Put the tie underneath your collar and adjust it, put the smaller part under the bigger part and you are done.
.jpg)
